2011-2013 Land Cruiser · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT FRONT STABILIZER LINK ASSEMBLY RH

C124387
  1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

  1. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

    Standard turning torque:
    0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)

    1. If the value is not within the specified range, replace the front stabilizer link with a new one.

  1. Check the dust boot for cracks or grease leakage.

← DISASSEMBLY (from Sep 2011)REASSEMBLY (from Sep 2011) →