Television Display Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This is the power source circuit of the television display assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND) |
![]() ![]() |
Disconnect the L53 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
L53-3 (GND) - Body ground
Always
Below 1 Ω
L53-4 (GND2) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
L53-11 (+B2) - Body ground
Always
11 to 14 V
L53-1 (+B) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Television Display Assembly)
|
|
||||
| OK | ||
| ||

