REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE FRONT DOOR SCUFF PLATE |
| 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
Remove the 2 screws.
Detach the 3 claws.
Disconnect the connectors and remove the No. 1 instrument panel under cover.
| 4. REMOVE COWL SIDE TRIM BOARD |
![]() ![]() |
Remove the cap nut.
Detach the 2 clips and remove the cowl side trim board.
| 5. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL |
![]() ![]() |
Using a screwdriver, detach the 2 claws and open the hole cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape
w/ Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 16 claws.


w/o Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 9 claws.


for Automatic Air Conditioning System:

Detach the 2 claws and remove the room temperature sensor.
Detach the 2 claws and disconnect the 2 control cables.

Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.
| 6. REMOVE NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Detach the 4 claws.
Disconnect the connectors and remove the No. 1 switch hole cover.
| 7. REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD) |
Detach the clamp and remove the buzzer.

Disconnect the buzzer connector.
| 8. REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD) |
Detach the clamp and remove the buzzer.

Disconnect the buzzer connector.




