2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the multi-media module receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly or multi-media module receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, multi-media module receiver assembly or speakers.

WIRING DIAGRAM

C253556E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the F78 multi-media module receiver assembly connector.

  1. Disconnect the z62 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F78-16 (ADPG) - z62-8 (AUXO)
    Always
    Below 1 Ω
    F78-7 (VAR+) - z62-5 (ARO)
    Always
    Below 1 Ω
    F78-8 (VAL+) - z62-6 (ALO)
    Always
    Below 1 Ω
    F78-15 (VA-) - z62-7 (ASGN)
    Always
    Below 1 Ω
    F78-5 (AGND) - z62-9 (AGND)
    Always
    Below 1 Ω
    F78-16 (ADPG) - Body ground
    Always
    10 kΩ or higher
    F78-7 (VAR+) - Body ground
    Always
    10 kΩ or higher
    F78-8 (VAL+) - Body ground
    Always
    10 kΩ or higher
    F78-15 (VA-) - Body ground
    Always
    10 kΩ or higher
    F78-5 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Sep 2011 – Dec 2011)Data Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Jan 2012) →