2011-2013 Land Cruiser · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011

NOTICE:
Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly.


1. INSTALL BRAKE DRUM OIL DEFLECTOR

  1. C160259E02
    Install a new deflector gasket and the deflector to the rear axle shaft.

    HINT:
    Align the 2 oil drain holes.

  1. C159723
    Temporarily install a washer and nut to 5 new hub bolts as shown in the illustration.

  1. Install the hub bolts by tightening each nut.

  1. Remove the washer and nut from each hub bolt.


2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
  1. Position the parking brake plate on a new rear axle hub and bearing.

    NOTICE:
    Make sure to securely fit the parking brake plate to the bearing.

  1. F042777
    Using 2 socket wrenches and a press, press in the 4 housing bolts.


3. INSTALL REAR AXLE SHAFT LH

  1. G022121E01
    Install the washer and a new retainer to the axle hub as shown in the illustration.

    NOTICE:
    1. Install the washer with its tapered surface facing downward.
    2. Install the retainer with its chamfered surface facing downward.

  1. Using SST and a press, press in the rear axle shaft.

    SST
    09631-12090  
    09726-40010  
    09951-01100  

    NOTICE:
    Make sure to securely fit the bearing to the rear axle shaft.


4. INSTALL REAR AXLE SHAFT SNAP RING LH

  1. C159455
    Using a snap ring expander, install a new snap ring.

← INSPECTION (from Sep 2011)INSTALLATION (from Sep 2011) →