2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester on.

  1. FI07052E34
    Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accelerator Position No. 1 and Accelerator Position No. 2.

  1. Read the value displayed on the intelligent tester.

    Standard Voltage:
    Accelerator Pedal Operation
    Accelerator Position No. 1
    Accelerator Position No. 2
    Released
    0.5 to 1.1 V
    1.2 to 2.0 V
    Depressed
    2.6 to 4.5 V
    3.4 to 5.0 V

    If the result is not as specified, check the accelerator pedal, wire harness and ECM.

← COMPONENTS (Sep 2011 – Dec 2011)REMOVAL (Sep 2011 – Dec 2011) →