2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

PRECAUTION

Precautions · Vehicles built from Sep 2011


1.IGNITION SWITCH EXPRESSION

HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Switch (Condition)
Ignition Switch off
LOCK
Off
Ignition Switch ACC
ACC
On (ACC)
Ignition Switch ON
ON
On (IG)
Engine Start
START
Start


2.FUEL SYSTEM

  1. Observe these precautions when disconnecting the fuel tube connector (for quick type A).

    1. A157617E03
      Detach the lock claw by lifting up the cover, as shown in the illustration.

    2. Check for dirt or mud on the pipe and around the connector before disconnection. Clean if necessary.

    3. A088336E20
      Pinch the connector and disconnect the connector and pipe.
      If the connector and the pipe are stuck together, pinch the connector, then push and pull the pipe to disconnect the pipe and pull it out.

      NOTICE:
      Do not use any tools in this procedure.

    4. Check for dirt or mud on the seal surface of the disconnected pipe. Clean if necessary.

    5. A099427E11
      To protect the disconnected pipe and connector from damage and contamination, cover it with a plastic bag.

  2. Observe these precautions when disconnecting the fuel tube connector (for quick type B).

    1. A167866E01
      Check that there is no damage or foreign matter on the part of the pipe that contacts the connector.

    2. A091246E02
      Detach the 2 claws of the connector retainer. Push down on the connector and disconnect it from the pipe.

      HINT:
      If the connector and pipe are stuck, pinch the fuel pipe by hand, and push and pull the connector to disconnect it.

      NOTICE:
      Do not use any tools in this procedure.

    3. Check for foreign matter on the seal surface of the disconnected pipe. Clean it if necessary.

    4. A103972E02
      To protect the disconnected pipe and connector from damage and foreign matter, cover it with a plastic bag.

  3. Observe these precautions when connecting the fuel tube connector (for quick type B).

    1. A125397E01
      Check for foreign matter on the pipe and around the connector before connecting it. Clean it if necessary.

    2. Align the axis of the connector with the axis of the pipe. Push the pipe into the connector, and push up on the retainer.

    3. A093435
      After connecting the pipe and connector, try to pull them apart to confirm that they are securely connected.

  4. A130944E01
    Observe these precautions when connecting the fuel tube connector (for quick type A).

    1. Check that there is no damage or contamination in the connected part of the pipe.

    2. Align the axis of the connector with the axis of the pipe. Push the pipe into the connector until the connector makes a "click" sound. If the connection is tight, apply a small amount of fresh spindle oil or gasoline on the tip of the pipe.

    3. A130945E02
      After having finished the connection, try to pull apart the pipe and the connector to confirm that they are securely connected.

    4. A157616E02
      Attach the lock claw to the connector by pushing down on the cover, as shown in the illustration.

    5. Check that there is no fuel leakage.


3.CHECK FOR FUEL LEAK
  1. Check that there are no fuel leaks after performing maintenance anywhere on the fuel system (Click here).

← ON-VEHICLE INSPECTION (from Jan 2012)PARTS LOCATION (from Sep 2011) →