2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT PURGE VSV

A162419E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    26 to 30 Ω
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground

    If the result is not as specified, replace the purge VSV.

  1. A134449E02
    Check operation of purge VSV.

    1. Check that air does not flow from port F when air is applied to port E.

    2. A134450E03
      Apply battery voltage to the connector, and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Air flows from port E to port F

      If the result is not as specified, replace the purge VSV.

← REMOVAL (from Jan 2012)INSPECTION (from Jan 2012) →