B2289 Key Collation Waiting Time Over
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when there is a LIN communication problem between the main body ECU and certification ECU (smart key ECU assembly) or when there is a problem in the engine immobiliser system.| DTC Code |
Detection Condition |
Trouble Area |
| B2289 |
When either of the following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Clear the DTCs (Click here).
Check whether DTC B2289 is output.
Result Result
Proceed to
DTC B2289 output
A
No DTC output
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |


Disconnect the 2D main body ECU connector.
Disconnect the E29 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2D-20 (LIN1) - E29-10 (LIN)
Always
Below 1 Ω
2D-20 (LIN) or E29-10 (LIN) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. REPLACE MAIN BODY ECU |
Temporarily replace the main body ECU with a new or normally functioning one.
Check whether DTC B2289 is output.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
