2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. REMOVE REAR ENGINE UNDER COVER SEAL

  1. A178890
    Remove the 2 bolts and cover seal.


5. REMOVE OIL FILLER CAP SUB-ASSEMBLY

6. DRAIN ENGINE OIL

  1. A178891
    Remove the oil drain plug and gasket, and drain the engine oil into a container.


7. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


A175216E01
  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.


8. REMOVE OIL FILTER ASSEMBLY

  1. A150109E01
    Using SST, remove the oil filter.
    SST
    09228-07501  


9. REMOVE OIL COOLER ASSEMBLY

  1. A178907
    Disconnect the 2 oil cooler hoses from the oil cooler.

  1. Remove the union bolt, plate washer and oil cooler.

  1. A150134E03
    Remove the gasket from the oil cooler.

← COMPONENTS (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →