REMOVAL
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF) |
Disconnect the air fuel ratio sensor connector.

Disconnect the 2 air hoses.

Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly from the center exhaust pipe assembly.
Remove the 3 nuts and front exhaust pipe.
Remove the 2 gaskets from the front exhaust pipe assembly.
| 2. REMOVE SPEED SENSOR NT |
![]() ![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.
| 3. REMOVE SPEED SENSOR SP2 |
![]() ![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.


