2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL FAN AND GENERATOR V BELT

  1. A163771E04
    Set the fan and generator V belt onto every part.
    Text in Illustration 
    *1
    Water Pump Pulley
    *2
    Fan Pulley
    *3
    No. 1 Idler Pulley
    *4
    Vane Pump Pulley
    *5
    Generator Pulley
    *6
    V-ribbed Belt Tensioner
    *7
    Crankshaft Pulley
    *8
    Cooler Compressor Pulley

  1. While turning the belt tensioner counterclockwise, remove the pin.

    NOTICE:
    Make sure that the fan and generator V belt is properly set on each pulley.

  1. Check that the belt fits properly in the ribbed grooves.

    HINT:
    Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.


2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the No. 1 engine under cover sub-assembly with the 10 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
  1. Push in the clip to install the front fender splash shield sub-assembly LH.

  1. Install the 3 bolts and screw.


4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Push in the clip to install the front fender splash shield sub-assembly RH.

  1. Install the 3 bolts and 2 screws.


5. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A274416E01
    Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
    Text in Illustration 
    *1
    Grommet
    *2
    Pin
    *3
    Hook
    *4
    Bracket

← REMOVAL (from Jan 2012)COMPONENTS (from Jan 2012) →