2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL REAR CRANKSHAFT OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.

  1. A236991E01
    Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
    SST
    09223-56010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap on the oil seal at an angle.


2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A163778E03
    Using SST, hold the crankshaft.
    SST
    09213-70011  
    09330-00021  

  1. A239173
    Install the crankshaft angle sensor rotor.
    Text in Illustration 
    V100135
    Engine Side

    HINT:
    1. Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.
    2. As the crankshaft angle sensor rotor is not reversible, be sure to install it so that it is facing in the direction shown in the illustration.

  1. A237717E01
    Install the drive plate and rear drive plate spacer onto the crankshaft.
    Text in Illustration 
    *1
    Drive Plate
    *2
    Rear Drive Plate Spacer
    V100135
    Automatic Transmission Side

    HINT:
    As the rear drive plate spacer and the drive plate are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

  1. Install the drive plate and ring gear and bolts.

    HINT:
    The bolts are tightened in 2 progressive steps.


    1. Clean the bolts and bolt holes.

    2. A192239E03
      Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

      Adhesive:
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Text in Illustration 
      *1
      Adhesive

    3. A238248E01
      Step 1:
      Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.

      Torque:
      30 N*m{ 301 kgf*cm , 22 ft.*lbf }

      NOTICE:
      1. Do not reuse the drive plate installation bolts.
      2. Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

    4. Mark the upside of each drive plate installation bolt with paint.

    5. Step 2:
      Tighten the cylinder head bolts another 90°.

    6. Check that the painted marks are now at a 90° angle to the upside.

      NOTICE:
      Do not start the engine for at least an hour after installing the drive plate.


3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →