2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)

3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A163778E02
    Using SST, hold the crankshaft.
    SST
    09213-70011  
    09330-00021  

  1. A238248
    Remove the 10 bolts, rear drive plate spacer, drive plate and crankshaft angle sensor rotor.


4. REMOVE REAR CRANKSHAFT OIL SEAL
  1. Using a knife, cut off the lip of the oil seal.

  1. A236990E01
    Using a screwdriver, pry out the oil seal.
    Text in Illustration 
    *1
    Cut Position

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →