REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE V-BANK COVER
|
 |
- Remove the 2 nuts and V-bank cover.
| 3.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
|
 |
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
| 4.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 5.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
|
 |
- Remove the 10 bolts and under cover.
| 6.
REMOVE FAN & GENERATOR V BELT
|
 |
- While releasing the belt tension by turning the belt tensioner counterclockwise, remove the fan and generator V belt from the belt tensioner.
| 7.
REMOVE FRONT FENDER APRON SEAL FRONT LH
|
 |
- Using a clip remover, remove the 4 clips and fender apron seal.
| 8.
REMOVE GENERATOR ASSEMBLY |
 |
- Remove the nut and disconnect the wire harness clamp bracket.
- Disconnect the generator connector.
Remove the terminal cap.
Remove the nut and disconnect the generator wire.
Remove the wire harness clamp.
Remove the bolt and disconnect the wire harness clamp bracket.
- Remove the 2 bolts and generator.