2011-2013 Land Cruiser · Service Manual Power Source / Network

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A174196E03
    Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Bracket
    *2
    Hook
    *3
    Pin
    *4
    Grommet


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable from the cable is reconnected (Click here).


3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A238241
    Remove the 10 bolts and No. 1 engine under cover.


6. REMOVE FAN AND GENERATOR V BELT

  1. A163770E03
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
    Text in Illustration 
    *1
    Bar

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.


7. REMOVE FRONT FENDER APRON SEAL FRONT RH

  1. A177003
    Using a clip remover, remove the 3 clips and fender apron seal.


8. REMOVE AIR CLEANER HOSE ASSEMBLY

  1. A243375
    Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.


9. REMOVE AIR CLEANER ASSEMBLY

  1. A174195
    Remove the 3 bolts and air cleaner.


10. DISCONNECT VANE PUMP ASSEMBLY

  1. A163289
    Remove the 2 bolts and disconnect the vane pump.


11. DISCONNECT OIL COOLER PIPE ASSEMBLY

  1. A174185
    Remove the 2 bolts and disconnect the oil cooler pipe.


12. REMOVE GENERATOR ASSEMBLY

  1. A177892
    Disconnect the generator connector.

  1. Remove the terminal cap and nut, and disconnect the generator wire.

  1. Remove the bolt and wire harness bracket from the generator.

  1. A177893
    Remove the 3 bolts, nut and generator.

  1. Remove the stud bolt.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →