2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

C172095
  1. Detach the clamp, and disconnect the connector from the protector.

  1. Remove the 3 bolts and protector.


2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

  1. Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.

    C175131E01

    NOTICE:
    1. When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
    2. Do not remove the shutter valves.


3. REMOVE FRONT WHEEL

4. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

  1. C172821
    Disconnect the connector.

  1. Remove the nut, bolt and sensor.


5. DISCONNECT SKID CONTROL SENSOR WIRE

C173472E01
  1. Remove the bolt and nut, and disconnect the sensor wire from the steering knuckle and suspension upper arm.


6. DISCONNECT STEERING KNUCKLE LH

  1. C178724
    Support the front suspension lower arm LH with a jack.

  1. Remove the clip and the nut.

  1. C155977E01
    Using SST, disconnect the upper ball joint from the steering knuckle.
    SST
    09628-62011  

    NOTICE:
    Do not damage the ball joint dust cover.


7. REMOVE FRONT FENDER APRON SEAL LH (w/ KDSS)

C173475
  1. Using a clip remover, remove the 3 clips and apron seal.


8. REMOVE FRONT FENDER APRON SEAL LH (w/o KDSS)

  1. C173474
    Using a clip remover, remove the 4 clips and apron seal.


9. REMOVE FRONT FENDER APRON SEAL REAR LH

C178878
  1. Using a clip remover, remove the 4 clips and apron seal.


10. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY

C173477
  1. Remove the nut, bolt, 2 washers and suspension upper arm.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →