INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
| 1. INSTALL STARTER ASSEMBLY |
Install the starter with the 2 bolts.

- Torque:
- 58 N*m{ 591 kgf*cm , 43 ft.*lbf }
Connect the starter connector.

Connect the starter wire with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Connect the terminal cap.
| 2. INSTALL FRONT FENDER APRON SEAL REAR LH |
Install the fender apron seal with the 4 clips.

| 3. INSTALL FRONT FENDER APRON SEAL LH |
Install the fender apron seal with the 4 clips.

| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
