SERVICE DATA
Specifications · Vehicles built from Sep 2011
| Starter assembly |
No-load characteristics current |
150 A or less at 11.5 V |
|
| Starter armature assembly |
Standard resistance |
Segment -Segment |
Below 1 Ω |
| Segment - Armature coil core |
10 kΩ or higher |
||
| Maximum circle runout |
0.05 mm (0.00197 in.) |
||
| Standard commutator diameter |
29 mm (1.14 in.) |
||
| Minimum commutator diameter |
28 mm (1.10 in.) |
||
| Standard undercut depth |
0.4 mm (0.0157 in.) |
||
| Minimum undercut depth |
0.2 mm (0.00787 in.) |
||
| Brush length |
Standard length |
14.4 mm (0.567 in.) |
|
| Minimum length |
9.0 mm (0.354 in.) |
||
| Brush spring |
Standard spring installed load |
22 to 27 N (2 to 3 kgf, 5.0 to 6.1 lbf) |
|
| Minimum spring installed load |
14 N (1 kgf, 3.1 lbf) |
||
| Magnet starter switch assembly |
Standard resistance |
Terminal 50 - Terminal C |
Below 1 Ω |
| Terminal 50 - Switch body |
Below 2 Ω |
||
| Starter relay |
Standard resistance |
3 - 5 |
10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2) |
| Below 1 Ω (Battery voltage is applied to terminals 1 and 2) | |||
| Starter cut relay |
Standard resistance |
3 - 5 |
10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2) |
| Below 1 Ω (Battery voltage is applied to terminals 1 and 2) | |||
| ACC relay (Main body ECU) |
Standard resistance |
2A-1 - 2D-8 |
10 kΩ or higher (Battery voltage is not applied between 2D-45 and 2D- 62) |
| Below 1 Ω (Battery voltage is applied between 2D-45 and 2D- 62) | |||
| Engine switch |
Standard resistance |
7 - 5 |
Below 1 Ω (Engine switch is pushed) |
| 2 - 5 |
Below 1 Ω (Engine switch is pushed) |
||
| 7 - 5 |
10 kΩ or higher (Engine switch is not pushed) |
||
| 2 - 5 |
10 kΩ or higher (Engine switch is not pushed) |
||