2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for the LH and RH side.
  2. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


2. REMOVE FRONT DOOR SCUFF PLATE

B181682
  1. Detach the 7 claws and 4 clips, and remove the scuff plate.


3. REMOVE REAR STEP COVER

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


4. REMOVE REAR DOOR SCUFF PLATE

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


5. REMOVE CENTER PILLAR GARNISH COVER

HINT:
  1. for Manual Seat:
    When removing the center pillar garnish cover, move the front seat and seatback to the foremost upright position.
  2. for Power Seat:
    When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.
  3. for Power Seat:
    After moving the front seat, disconnect the cable from the negative (-) battery terminal.

  1. B181676
    Detach the 2 clips and 2 guides, and remove the cover.


6. REMOVE CENTER LOWER PILLAR GARNISH

B181677

HINT:
  1. for Manual Seat:
    When removing the center pillar garnish cover, move the front seat and seatback to the foremost upright position.
  2. for Power Seat:
    When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.
  3. for Power Seat:
    After moving the front seat, disconnect the cable from the negative (-) battery terminal.

  1. Remove the bolt and seat belt's anchor.

  1. B181678
    Detach the 2 claws and 7 clips, and remove the center lower pillar garnish.


7. REMOVE REAR ASSIST GRIP ASSEMBLY

B181679

HINT:
Use the same procedure to remove the rear assist grip on the other side.

  1. Detach the 4 claws and remove the 2 assist grip plugs.

  1. B181680
    Remove the 2 bolts.

  1. Detach the 2 claws and remove the rear assist grip.


8. REMOVE CENTER PILLAR GARNISH

B181681
  1. Remove the bolt.

  1. Detach the 2 clips and 2 guides.

  1. Pass the seat belt anchor through the center pillar garnish, and remove the center pillar garnish.


9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B180622
  1. Remove the nut and shoulder anchor.

  1. B180623E01
    Disconnect the pretensioner connector labeled A as shown in the illustration.

  1. Disconnect the tension reducer connector labeled B.

  1. w/ Pre-Crash Safety System:
    Disconnect the pre-crash safety connector labeled C.

  1. B180624
    Remove the bolt and seat belt.


10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B184509
  1. Remove the 2 bolts and adjuster.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →