2011-2013 Land Cruiser · Service Manual Vehicle Interior

IG Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the engine switch is on (IG). The power source is used for operating the air conditioning amplifier assembly and servo motor, etc.

WIRING DIAGRAM

E160326E03

INSPECTION PROCEDURE

HINT:
Start the engine before inspection. Check the relay or battery if the entry and start system does not start.


1. INSPECT FUSE (ECU-IG NO. 2)
  1. Remove the ECU-IG NO. 2 fuse from the cowl side junction block LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG NO. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
E158189E01
  1. w/ Rear Heater

    1. Disconnect the E35 and E36 amplifier connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      E36-5 (IG+) - Body ground
      Engine switch off
      Below 1 V
      Engine switch on (IG)
      11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E36-1 (GND) - Body ground
      Always
      Below 1 Ω
      E36-2 (E1) - Body ground
      E35-6 (E2) - Body ground

  1. E160300E05
    w/o Rear Heater
    1. Disconnect the E81 amplifier connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      E81-1 (IG+) - Body ground
      Engine switch off
      Below 1 V
      Engine switch on (IG)
      11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E81-14 (GND) - Body ground
      Always
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← Rear Magnetic Valve Circuit (from Sep 2011)IG Power Source Circuit (from Jan 2012) →