IG Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is turned to ON. The power source is used for operating the air conditioning amplifier assembly, servo motors, etc.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND) |
Disconnect the E81 air conditioning amplifier assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E81-1 (IG+) - Body ground
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E81-14 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)
|
|
||||
| OK | ||
| ||
