2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. REMOVE FRONT FENDER MUDGUARD LH

B180881
  1. Remove the clip.

  1. Using a T30 "TORX" socket, remove the 4 screws and mudguard.


2. REMOVE SIDE STEP ASSEMBLY LH

  1. Remove the 6 bolts and side step.

    B180949


3. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH
  1. Remove the 8 side mudguard retainers and screw.

  1. Detach the 10 clips and remove the rocker panel moulding.

    B180958E01


4. REMOVE FRONT FENDER LINER LH
  1. Remove the 2 screws.

  1. Using a T30 "TORX" socket, remove the 2 screws.

  1. Using a clip remover, remove the 2 grommets, 12 clips and fender liner.

    E156166


5. DRAIN WASHER FLUID

  1. E156158
    Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.


6. REMOVE WASHER INLET SUB-ASSEMBLY

  1. E156159
    Using a clip remover, remove the clip and washer inlet.


7. REMOVE WINDSHIELD WASHER JAR ASSEMBLY

  1. E156160E01
    w/ Headlight Cleaner System:

    1. Detach the clamp.

    2. Disconnect the 2 connectors.

    3. Disconnect the headlight cleaner hose.

  1. w/o Headlight Cleaner System:

    1. Detach the clamp.

    2. Disconnect the connector.

  1. E156161
    Remove the 4 bolts. Then remove the windshield washer jar.


8. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY

  1. E156156
    Remove the washer motor together with the gasket in the direction shown in the illustration.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →