ON-VEHICLE INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT REAR WASHER NOZZLE |
With the engine running, check that the center stream of washer fluid sprays on the back door glass within the hatched area shown in the illustration.
- Standard:
- Washer fluid hits the back door glass in the area shown in the illustration.


- Standard Measurement:
Area
Specified Condition
A
33 mm (1.30 in.)
B
18 mm (0.71 in.)
C
100 mm (3.94 in.)
D
48.5 mm (1.91 in.)
If the result is not as specified, adjust the rear washer nozzle.Text in Illustration *1
Back Door Glass Edge
