2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

  1. A258326
    Apply high-temperature grease to the areas of the starter pinion drive lever indicated in the illustration.
    Text in Illustration 
    V100135
    High-temperature grease

  1. Install the starter pinion drive lever and rubber seal to the starter center bearing clutch.

  1. Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal to the starter drive housing.

  1. A258327
    Apply high-temperature grease to the planetary gears and pins of the starter center bearing clutch.
    Text in Illustration 
    V100135
    High-temperature grease

  1. Install the 3 planetary gears.


2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.

    NOTICE:
    The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. A215977
    Push out the 4 brushes from the brush holder so that they are held in place by the springs as shown in the illustration.

  1. A215968
    Install the brush holder to the starter armature and push in the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. A187223E09
    Insert the grommet between the positive side and negative side.
    Text in Illustration 
    *1
    Grommet
    *2
    Negative Side
    *3
    Positive Side


4. INSTALL STARTER YOKE ASSEMBLY

  1. A258328E02
    Install the starter armature plate to the starter yoke.
    Text in Illustration 
    *1
    Key A
    *2
    Key B

    NOTICE:
    Install the starter armature plate so that the keyway is positioned between key A and key B.

  1. Install the commutator end frame with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. A258329E02
    Align the key of the starter yoke with the keyway located on the starter drive housing.
    Text in Illustration 
    *1
    Keyway
    *2
    Key

  1. Using a T25 "TORX" socket wrench, install the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


5. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A258330
    Apply high-temperature grease to the plunger hook.
    Text in Illustration 
    V100135
    High-temperature grease

  1. Hang the plunger of the magnet starter switch onto the drive lever from the upper side.

  1. Install the magnet starter switch with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the lead wire to the magnet starter switch with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →