INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT ENGINE SWITCH |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
7 (SS1) - 5 (GND)
Not pushed
10 kΩ or higher
2 (SS2) - 5 (GND)
Not pushed
10 kΩ or higher
7 (SS1) - 5 (GND)
Pushed
Below 1 Ω
2 (SS2) - 5 (GND)
Pushed
Below 1 Ω


If the result is not as specified, replace the engine switch.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- HINT:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- If the voltage is too low, the indicator will not illuminate.
- If the voltage is too low, the indicator will not illuminate.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND)
Illuminates (illumination of lettering)
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND)
Illuminates (green)
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND)
Illuminates (amber)


If the result is not as specified, replace the engine switch.
