2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT ENGINE SWITCH

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS1) - 5 (GND)
    Not pushed
    10 kΩ or higher
    2 (SS2) - 5 (GND)
    Not pushed
    10 kΩ or higher
    7 (SS1) - 5 (GND)
    Pushed
    Below 1 Ω
    2 (SS2) - 5 (GND)
    Pushed
    Below 1 Ω


    B106647E16
    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    HINT:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    1. If the voltage is too low, the indicator will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (illumination of lettering)
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (green)
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (amber)


    A178861E01
    If the result is not as specified, replace the engine switch.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →