SYSTEM DIAGRAM
System information · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


| No. |
ECU/Sensor Name |
| 1 |
ECM |
| 2 |
Network Gateway ECU |
| 3 |
Main Body ECU (Cowl Side Junction Block LH) |
| 4 |
DLC3 |
| 5 |
Air Conditioning Amplifier |
| 6 |
Center Airbag Sensor Assembly*11 |
| 7 |
Multi-display*1 |
| 8 |
Combination Meter |
| 9 |
Certification ECU (Smart Key ECU)*2 |
| 10 |
Multiplex Tilt and Telescopic ECU*3 |
| 11 |
Outer Mirror Control ECU*4 |
| 12 |
Windshield Wiper ECU*5 |
| 13 |
Position Control ECU and Switch*4 |
| 14 |
Master Cylinder Solenoid (Skid Control ECU) |
| 15 |
Yaw Rate Sensor |
| 16 |
Steering Control ECU*6 |
| 17 |
Steering Angle Sensor |
| 18 |
4WD Control ECU |
| 19 |
|
| 20 |
Seat Belt Control ECU*9 |
| 21 |
Suspension Control ECU*10 |
| 22 |
No. 1 CAN Junction Connector |
- HINT:
- *1: w/ Navigation System
- *2: w/ Entry and Start System
- *3: w/ Power Tilt and Power Telescopic Steering Column System
- *4: w/ Seat Memory
- *5: w/ Rain Sensor
- *6: w/ Variable Gear Ratio Steering System
- *7: w/ Parking Assist Monitor System
- *8: w/ TOYOTA Parking Assist-sensor System
- *9: w/ Pre-Crash Safety System
- *10: w/ Active Height Control Suspension
- *11: w/ Airbag System






- HINT:
- The ABS and traction actuator (skid control ECU) stores steering sensor and yaw rate sensor DTCs and performs DTC communication by receiving information from the steering sensor and yaw rate sensor.
- The ECM uses the CAN communication system to perform DTC communication instead of the conventional communication line (SIL).
- The ABS and traction actuator (skid control ECU) stores steering sensor and yaw rate sensor DTCs and performs DTC communication by receiving information from the steering sensor and yaw rate sensor.