2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT DOOR CONTROL SWITCH ASSEMBLY

  1. B180461E06
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (UL) - 3 (E)
    Unlock
    Below 1 Ω
    2 (UL) - 3 (E)
    Off
    10 kΩ or higher
    4 (L) - 3 (E)
    4 (L) - 3 (E)
    Lock
    Below 1 Ω

    1. If the result is not as specified, replace the door control switch assembly.
    Text in Illustration 
    *a
    Unlock
    *b
    Lock
    *c
    Component without harness connected
    (Door Control Switch Assembly)

  1. B180462E02
    Apply battery voltage to the switch connector and check that the indicator (LED) illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1 (IG)
    Battery negative (-) → Terminal 3 (E)
    Indicator (LED) illuminates

    If the result is not as specified, replace the door control switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Door Control Switch Assembly)

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →