REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 3.
REMOVE LOWER NO. 3 STEERING WHEEL COVER
|
 |
- Detach the 2 claws and remove the steering wheel cover.
| 4.
REMOVE LOWER NO. 2 STEERING WHEEL COVER
|
 |
- Detach the 2 claws and remove the steering wheel cover.
| 5.
REMOVE STEERING PAD
|
 |
- Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
- Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 6.
REMOVE STEERING WHEEL ASSEMBLY
|
 |
Remove the steering wheel set nut.
- Put matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel assembly.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05011)
| 7.
REMOVE LOWER STEERING COLUMN COVER
|
 |
- Remove the 3 screws.
Detach the 2 claws to remove the lower steering column cover.
- NOTICE:
- Do not damage the tilt and telescopic switch.
| 8.
REMOVE UPPER STEERING COLUMN COVER
|
 |
- Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 9.
REMOVE SPIRAL CABLE |
 |
- Disconnect the connectors from the spiral cable with steering sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the 3 claws and remove the spiral cable with steering sensor.
- Detach the 6 claws and remove the spiral cable from the steering sensor.