2011-2013 Land Cruiser · Service Manual Steering

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Jan 2012


HEATED STEERING WHEEL SYSTEM
  1. The heated steering wheel heats the steering wheel when the steering heater switch is operated.

  2. The heated steering wheel uses a thermistor inside of the steering wheel to detect the heater temperature and maintain the set temperature.

  3. The heated steering wheel timer function turns off the heater after a predetermined period of time.


HEATER CONTROLLER SYSTEM

  1. Operation description
    C147022E05

    1. When the ignition switch is ON, pressing the steering wheel controller momentary switch on the steering heater switch illuminates the LED and current is output from the steering controller to the heater of the heated steering wheel. Pressing the momentary switch again turns off the LED and stops the current from being output.

    2. A thermostat is installed in the steering wheel as a safety mechanism.

    3. The heated steering wheel switch LED will blink at 0.3 second intervals when either of the following occurs: 1) an open or short in the steering wheel thermistor continues for 2 seconds or more; or 2) the steering heater switch momentary switch is pressed continuously for 10 seconds or more.

    4. If the normal condition is restored for 2 seconds or more, the previous operation before the malfunction occurred continues. However, regardless of if a malfunction is detected and the malfunction operation is occurring, and regardless of if the normal condition is restored and the system is operating normally, the timer will turn off the heater 30 minutes after the switch was first turned on.

  2. Signal input / output description
    C147023E03

    Signal
    Signal Name
    Function
    Signal Type
    Input
    Thermistor input
    Input of voltage corresponding to heater temperature
    Analog input
    Input
    Temperature setting input
    Input of voltage corresponding to temperature setting
    Analog input
    Input
    Operating switch input
    Input of power circuit latch operation estimate signal
    LOW / HI input
    Output
    LED output
    Output of LED
    LOW / HI input
    Output
    Heater output
    Output of heater
    LOW / HI input
    Output
    Latch output
    Power circuit maintenance
    LOW / HI input

  3. Safety function

    Content
    Operation
    When thermistor trouble is detected
    Heater off
    When overheating (175°C (347°F)) of controller is detected
    Heater off
    When load short current (50 A or more) is detected
    Heater off
    When undervoltage (4.5 V) is detected
    Heater off
    OFF timer (30 min.)
    After preset time of timer passes, heater off
    Reverse voltage protection
    Protection circuit operates

← SYSTEM DIAGRAM (from Jan 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →