2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE INTAKE VALVE

  1. A164326E02
    Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


2. REMOVE EXHAUST VALVE

  1. A164327E02
    Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE VALVE STEM OIL SEAL

  1. A164328
    Using needle-nose pliers, remove the oil seals.


4. REMOVE VALVE SPRING SEAT

  1. A164329
    Using compressed air and a magnet hand, remove the valve spring seat by blowing air onto it.


5. REMOVE NO. 1 STRAIGHT SCREW PLUG

A174132E02

NOTICE:
If water leaks from the No. 1 straight screw plug or the plug is corroded, replace it.

  1. Using a 10 mm hexagon wrench, remove the 6 screw plugs and 6 gaskets.

    Text in Illustration 
    *A
    LH
    *B
    RH


6. REMOVE NO. 2 STRAIGHT SCREW PLUG

A174133E02

NOTICE:
If water leaks from the No. 2 straight screw plug or the plug is corroded, replace it.

  1. Using a 14 mm hexagon wrench, remove the 2 screw plugs and 2 gaskets.

    Text in Illustration 
    *A
    LH
    *B
    RH


7. REMOVE STUD BOLT

NOTICE:
If the stud bolt is deformed or its threads are damaged, replace it.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →