2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2012


1. REMOVE INTAKE VALVE

  1. A164326E03
    Using SST, compress the compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, compression spring and intake valve.

    HINT:
    Arrange the removed parts in the correct order.


2. REMOVE EXHAUST VALVE

  1. A164327E03
    Using SST, compress the compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, compression spring and exhaust valve.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE VALVE STEM OIL SEAL

  1. A164328
    Using needle-nose pliers, remove the valve stem oil seals.


4. REMOVE VALVE SPRING SEAT

  1. A164329
    Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.


5. REMOVE NO. 1 STRAIGHT SCREW PLUG

A145550E04

NOTICE:
If coolant leaks from a No. 1 straight screw plug or a plug is corroded, replace it.

  1. Using a 10 mm hexagon wrench, remove the 6 No. 1 straight screw plugs and 6 gaskets.

    Text in Illustration 
    *A
    for Bank 2
    *B
    for Bank 1


6. REMOVE NO. 2 STRAIGHT SCREW PLUG

A164330E03

NOTICE:
If coolant leaks from a No. 2 straight screw plug or a plug is corroded, replace it.

  1. Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.

    Text in Illustration 
    *A
    for Bank 2
    *B
    for Bank 1


7. REMOVE STUD BOLT

NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.

← COMPONENTS (from Jan 2012)INSPECTION (from Jan 2012) →