2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit provides power to the windshield wiper ECU and operates the front wiper motor.

WIRING DIAGRAM

E138462E03

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG No. 1)
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER ECU - BATTERY AND BODY GROUND)

  1. E157235E01
    Disconnect the E83 and E85 windshield wiper ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E83-5 (IG1L) - Body ground
    Engine switch on (IG)
    11 to 14 V
    E83-5 (IG1L) - Body ground
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E85-10 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE WINDSHIELD WIPER ECU (Click here)


← ECU Power Source Circuit (Sep 2011 – Dec 2011)PARTS LOCATION (from Sep 2011) →