2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Washer Motor Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The windshield wiper ECU receives washer switch information from the front wiper switch, and operates the washer motor.

WIRING DIAGRAM

E159009E01

INSPECTION PROCEDURE


1. INSPECT FRONT WASHER MOTOR

  1. E147180E01
    Remove the front washer motor (Click here).

  1. Apply battery voltage to the windshield washer motor and check the operation of the windshield washer motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Front washer motor operation is normal



NG
REPLACE FRONT WASHER MOTOR (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (FRONT WASHER MOTOR - BODY GROUND)

  1. E158957E01
    Disconnect the A16 front washer motor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A16-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH - BODY GROUND)

  1. E159008E01
    Disconnect the E16 windshield wiper switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (FRONT WASHER MOTOR - WINDSHIELD WIPER SWITCH)

  1. E158386E02
    Disconnect the E15 windshield wiper switch connector.

  1. Disconnect the A16 washer motor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    A16-2 - E15-3 (WF)
    Always
    Below 1 Ω
    A16-2 - Body ground
    Always
    10 kΩ or higher
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    A16-2 - E15-1 (WF)
    Always
    Below 1 Ω
    A16-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE WINDSHIELD WIPER SWITCH (Click here)


← Washer Motor Circuit (Sep 2011 – Dec 2011)ECU Power Source Circuit (Sep 2011 – Dec 2011) →