2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT ENGINE COOLANT TEMPERATURE SENSOR

A231302E01
Text in Illustration 
*1
Resistance
*2
Temperature
*3
Acceptable Range
-
-
*a
Component without harness connected
(Engine Coolant Temperature Sensor)
-
-
  1. Partially immerse the sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approx. 20°C (68°F)
    2.32 to 2.59 kΩ
    1 - 2
    Approx. 80°C (176°F)
    0.310 to 0.326 kΩ

    If the result is not as specified, replace the engine coolant temperature sensor.

    NOTICE:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.

    HINT:
    If the result is as specified, do not replace the engine coolant temperature sensor.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →