2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
  1. Remove the adhesive from the threads of the oil pressure sender gauge and the bolt hole of the oil filter bracket.

  1. A161955E01
    Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    NOTICE:
    Do not apply adhesive to the oil inlet port of the sensor.

  1. A170281
    Install the oil pressure sender gauge.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour after installation.

  1. Connect the oil pressure sender gauge connector.


2. ADD ENGINE OIL
  1. Add fresh oil.

    Standard Engine Oil:
    Item
    Oil Grade
    Oil Viscosity (SAE)
    w/ DPF
    ACEA C2
    (Using engine oil other than ACEA C2 may damage catalytic converter)
    - 0W-30
    - 5W-30
    (0W-30 is best choice for fuel economy and good starting in cold weather)
    w/o DPF
    G-DLD-1, API CF-4, API CF or ACEA B1
    (You may also use API CE or CD)
    - 5W-30
    - 10W-30
    - 15W-40
    - 20W-50
    (5W-30 is best choice for fuel economy and good starting in cold weather).


    Standard Capacity:
    Item
    Specified Condition
    Drain and refill with oil filter change
    9.2 liters (9.7 US qts, 8.1 Imp. qts)
    Drain and refill without oil filter change
    8.2 liters (8.7 US qts, 7.2 Imp. qts)
    Dry fill
    9.9 liters (10.5 US qts, 8.7 Imp. qts)

  1. Install the oil filler cap.


3. INSPECT FOR ENGINE OIL LEAK
  1. Warm up the engine and check for an engine oil leak.


4. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the No. 1 engine under cover with the 10 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Push in the clip to install the front fender splash shield sub-assembly RH.

  1. Install the 3 bolts and 2 screws.


7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
  1. Push in the clip to install the front fender splash shield sub-assembly LH.

  1. Install the 3 bolts and screw.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →