REMOVAL
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
|
 |
- Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.
| 2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
|
 |
- Remove the 3 bolts and 2 screws.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
| 3.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
|
 |
- Remove the 10 bolts and No. 1 engine under cover.
| 4.
DRAIN ENGINE OIL
|
 |
- Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
-
Torque:
- 38 N*m{
387 kgf*cm
, 28 ft.*lbf
}
| 5.
REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY |
 |
- Disconnect the oil pressure sender gauge connector.
Remove the oil pressure sender gauge.