2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011


1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    A160713E04

    Text in Illustration 
    *A
    Upper Side
    *B
    Front Side
    *C
    Lower Side
    *D
    Rear Side

    Standard Protrusion:
    Item
    Pin Diameter
    Specified Condition
    Pin A
    10 mm (0.394 in.)
    23 mm (0.906 in.)
    Pin B
    10 mm (0.394 in.)
    11 mm (0.433 in.)
    Pin C
    8 mm (0.315 in.)
    9 mm (0.354 in.)
    Pin D
    4 mm (0.157 in.)
    6 mm (0.236 in.)

← INSPECTION (from Sep 2011)REASSEMBLY (from Sep 2011) →