2011-2013 Land Cruiser · Service Manual Vehicle Exterior

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


ILLUMINATED ENTRY SYSTEM
  1. except Double Swing Out Type:
    When the doors are unlocked by a key or door control transmitter operation, when a door is opened or closed, or when the vehicle is approached while holding the door control transmitter, the illuminated entry system turns on the room light, map light and engine switch illumination.
    for Double Swing Out Type:
    When the doors are unlocked by a key or door control transmitter operation, when a door is opened or closed, the illuminated entry system turns on the room light and map light.

    1. The main body ECU receives the following signals (A).

      1. Door control switch signal
      2. Door detection switch signal
      3. Ignition switch signal

    2. The main body ECU controls the following signal based on the signals listed in A.

      1. Illumination operation signal

    3. The main body ECU controls the on/off and fade-in/fade-out operation of the following parts.

      1. Room light
      2. Map light
      3. Engine switch illumination*
      1. *: except Double Swing Out Type


BATTERY SAVE SYSTEM
  1. *: except Double Swing Out Type
  1. When the ignition switch is turned off and any of the doors is open continuously for 20 minutes, the main body ECU turns the illumination operation signal off. As a result, the room light, map light and engine switch illumination* turn off.

    NOTICE:
    If the map light and/or room light is turned on manually, they do not turn off automatically by the battery save system.


    1. The main body ECU receives the following signals (B).

      1. Door courtesy light switch signal
      2. Ignition switch signal

    2. The main body ECU controls the following signal based on the signal listed in B (C).

      1. Illumination operation signal

    3. The main body ECU controls the illumination period of the following parts based on the signal listed in C.

      1. Room light
      2. Map light
      3. Engine switch illumination*


MANUAL LIGHT CONTROL SYSTEM
  1. This system functions when lights such as the headlight, taillight and front fog light are illuminated by manual operation of the light control switch.

    1. The main body ECU receives the following signals (D).

      1. Light control switch signal
      2. Headlight dimmer switch signal
      3. Front fog light switch signal
      4. Rear fog light switch signal

    2. The main body ECU controls the following signals based on the signals listed in D (E).

      1. Headlight relay operation signal
      2. Taillight relay operation signal
      3. Front fog light relay operation signal
      4. Rear fog light relay operation signal

    3. The main body ECU controls the on/off operation of the following parts based on the signal listed in E.

      1. Headlight (Low)
      2. Headlight (High)
      3. Front fog light
      4. Rear fog light


LIGHT AUTO TURN OFF SYSTEM
  1. When the headlight and taillight are both illuminated by the operation of the light control switch, if the ignition switch is turned off, this system turns the headlights and fog lights off immediately. However, when all the doors are locked using the door control switch, emergency key or transmitter lock switch, this system turns the headlight and taillight off immediately. Also, when only the taillight is illuminated by the operation of the light control switch, if the ignition switch is turned off and the driver door is opened, this system turns the headlight, taillights, and fog lights off immediately.

    1. The main body ECU receives the following signals (F).

      1. Door courtesy light switch signal
      2. Ignition switch signal

    2. The main body ECU controls the following signals based on the signals listed in F (G).

      1. Headlight relay operation signal
      2. Taillight relay operation signal
      3. Fog light relay operation signal

    3. The main body ECU controls the on/off operation of the following parts based on the signal listed in G.

      1. Headlight (Low)
      2. Headlight (High)
      3. Taillight
      4. Fog light

← SYSTEM DIAGRAM (from Jan 2012)SYSTEM DESCRIPTION (from Jan 2012) →