2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


INSPECT ENTRY LOCK AND UNLOCK SWITCH

B184271E01
  1. Disconnect the connector.

  1. Remove the outside handle.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (TRG-) - 3 (TRG+)
    Lock switch not pushed (OFF)
    10 kΩ or higher
    1 (TRG-) - 3 (TRG+)
    Lock switch pushed (ON)
    Below 1 Ω

    1. If the result is not as specified, replace the entry lock and unlock switch.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →