2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT LUMBAR SWITCH LH (for LHD)

B165793E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (B) - 4 (H)
    Hold
    Below 1 Ω
    1 (R) - 2 (E2)
    1 (R) - 2 (E2)
    Off
    4 (H) - 5 (E2)
    1 (R) - 3 (B)
    Release
    4 (H) - 5 (E2)

    If the result is not as specified, replace the lumbar switch.


INSPECT LUMBAR SWITCH RH (for RHD)

B190725E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (B) - 4 (H)
    Hold
    Below 1 Ω
    1 (R) - 2 (E)
    1 (R) - 2 (E)
    Off
    4 (H) - 5 (E)
    1 (R) - 3 (B)
    Release
    4 (H) - 5 (E)

    If the result is not as specified, replace the lumbar switch.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →