2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT SEAT HEATER SWITCH (w/ Seat Heater System)

B298410E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (VSL) - 12 (VGL)
    COLD (HI) to HOT (HI)
    6.0 to 0.06 kΩ

    Standard Resistance:
    for RH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (VSR) - 11 (VGR)
    COLD (HI) to HOT (HI)
    6.0 to 0.06 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the seat heater switch.
    Text in Illustration 
    *a
    COLD (HI)
    *b
    HOT (HI)
    *c
    Component without harness connected
    (Seat Heater Switch)
    If the result is not as specified, replace the seat heater switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 7 (ILL+)
    Battery negative (-) → 5 (ILL-)
    Illuminates

    If the result is not as specified, replace the seat heater switch.


INSPECT SEAT HEATER SWITCH (w/o Seat Heater System)

B311212E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (VSL) - 12 (VGL)
    ON (MIN) to ON (MAX)
    6.0 to 0.06 kΩ

    Standard Resistance:
    for RH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (VSR) - 11 (VGR)
    ON (MIN) to ON (MAX)
    6.0 to 0.06 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the seat heater switch.
    Text in Illustration 
    *a
    ON (MIN)
    *b
    ON (MAX)
    *c
    Component without harness connected
    (Seat Heater Switch)

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 5 (ILL-)
    Illuminates

    If the result is not as specified, replace the seat heater switch.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →