Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Standard bush bore diameter:
10.985 to 11.006 mm (0.432 to 0.433 in.)
If the bush bore diameter of the cylinder head is more than 11.006 mm (0.433 in.), machine the bush bore to the dimension of 11.035 to 11.056 mm (0.434 to 0.435 in.).
Standard Valve Guide Bush Diameter:
Item
Specified Condition
STD
11.033 to 11.044 mm (0.434 to 0.435 in.)
O/S 0.05
11.083 to 11.094 mm (0.436 to 0.437 in.)
If the bush bore diameter of the cylinder head is more than 11.056 mm (0.435 in.), replace the cylinder head sub-assembly.
Gradually heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on a wooden block.
Using SST, tap in a new valve guide bush to the specified protrusion height A shown in the illustration.