2011-2013 Land Cruiser · Service Manual Suspension

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL FRONT COIL SPRING LH

C159782E02
  1. Using SST, compress the coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    1. Do not compress the coil spring more than necessary.
    2. Do not use an impact wrench. It will damage SST.

  1. C155966E01
    Install the coil spring to the shock absorber.

    HINT:
    Fit the lower end of the coil spring into the recess of the spring seat of the shock absorber.


2. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Install the 2 cushions, 2 retainers and suspension support to the piston rod.

  1. Temporarily install a new front shock absorber nut to the suspension support.

  1. Position the suspension support as shown in the illustration.

    C173244E01

  1. Remove SST.

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

    HINT:
    Release the coil spring while checking the position of the suspension support.


3. TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
  1. Tighten the nut.

    Torque:
    65 N*m{ 575 kgf*cm , 48 ft.*lbf }

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →