REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
- CAUTION:
- The procedures should be performed by at least 2 people.
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.
- The procedures should be performed by at least 2 people.
| 1. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and No. 2 engine under cover.

| 2. REMOVE TAILPIPE ASSEMBLY |
Remove the bolt, clamp and gasket.
Remove the tailpipe from the 2 exhaust pipe supports.
| 3. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
Remove the 4 bolts.
Remove the center exhaust pipe from the 3 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.
| 4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Remove the 3 nuts, front No. 2 exhaust pipe and gasket.
| 5. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Detach the heated oxygen sensor wire clamp.
Remove the 3 nuts, front exhaust pipe and gasket.
| 6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
Using SST, remove the sensor.

- SST
- 09224-00010
| 7. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
Using SST, remove the sensor.

- SST
- 09224-00010
