2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060A Internal Control Module Monitoring Processor Performance

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P060A
When one of the following conditons is met:
  1. An ECM main CPU error.
  2. An ECM sub CPU error.
  3. An electronic throttle monitoring CPU error.
ECM

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG).

  1. Check DTC.

    OK:
    P060A is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060A Internal Control Module Monitoring Processor Performance (Sep 2011 – Dec 2011)P060B Internal Control Module A/D Processing Performance (Sep 2011 – Dec 2011) →