2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060D Internal Control Module Accelerator Pedal Position Performance

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals deviate, this DTC is stored.
DTC No.
DTC Detection Condition
Trouble Area
P060D
There is an ECM main CPU error (1 trip detection logic).
ECM

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check for DTCs.

    OK:
    P060D is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060D Internal Control Module Accelerator Pedal Position Performance (Sep 2011 – Dec 2011)P060E Internal Control Module Throttle Position Performance (Sep 2011 – Dec 2011) →