2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISPOSAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. DISPOSE OF HOOD SUPPORT ASSEMBLY

  1. B184535E01
    Horizontally fix the hood support in a vise with the piston-rod pulled out.

  1. Wear safety glasses. Gradually cut a part between A and B shown in the illustration using a metal saw and gradually release the gas.

    Standard Measurement:
    Area
    Specified Condition
    a
    150 mm (5.91 in.)
    b
    20 mm (0.787 in.)

    CAUTION:
    As metal debris may be blown outward by the gas, you must:
    1. Wear protective glasses.
    2. Cover the area being cut.

    NOTICE:
    The gas inside the hood support is colorless, odorless and harmless. As there is a possibility that metal debris could scatter, cover the hood support with a piece of cloth or other material.

← INSTALLATION (from Sep 2011)COMPONENTS (Sep 2011 – Dec 2011) →