2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ADJUSTMENT

Removal / installation · Vehicles built from Sep 2011

B057104E06

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSPECT HOOD SUB-ASSEMBLY

  1. Check that the clearance measurements of areas A to C are within the standard range.

    B182245E01

    Standard Measurement:
    Area
    Specified Condition
    A (Reference)
    2.3 to 5.3 mm (0.0906 to 0.209 in.)
    B
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    C
    -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)


2. ADJUST HOOD SUB-ASSEMBLY

  1. B182246
    Adjust the hood position.

    1. Loosen the 4 hinge bolts of the hood.

    2. Move the hood and adjust the clearance between the hood and front fender.

    3. Tighten the 4 hinge bolts of the hood after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

    4. B182247
      Adjust the cushion rubber so that the height of the hood and fender are aligned.

      HINT:
      Raise or lower the hood front end by turning the cushion rubber.

  1. Adjust the hood lock.

    1. B182248
      Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

      HINT:
      Tape the screwdriver tip before use.

    2. B182249
      Loosen the 2 bolts and hood lock nut.

    3. Adjust the hood lock position so that the striker can enter it smoothly.

    4. Tighten the bolts and nut after the adjustment.

      Torque:
      5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    5. Install a new cap.

← Power Back Door Sensor Circuit (from Jan 2012)COMPONENTS (from Sep 2011) →